I know where the config is and all and these the settings I have;
throttle_key=(-0.874973,0.874973)WirelessController axis 0
front_brake_key=(k)WirelessController button 4
rear_brake_key=(-0.874973,0.874973)WirelessController axis 1
left_key=(0.100000,-0.931517)WirelessController axis 5
right_key=(0.100000,0.943922)WirelessController axis 5
clutch_key=(k)WirelessController button 5
upshift_key=(k)WirelessController button 3
downshift_key=(k)WirelessController button 2
dab_key=(k)WirelessController button 1
back_up_key=(k)WirelessController button 0
lean_forward_key=(-0.084471,-0.938936)WirelessController axis 4
lean_backward_key=(0.077404,0.938465)WirelessController axis 4
I simple don't know what to change to increase the deadzone range. For example when I don't do anything on the start gate my bars go to the right a bit much. Anyone know anything about it? Also if there is something recommended for the game?
I play rocket league which have general deadzone recommendations. Example;(From 0.05-0.10)
And if anyone could tell me how it works would be a great help!
Can't figure out how to change my deadzone. Stick drift
Re: Can't figure out how to change my deadzone. Stick drift
Increase the magnitude of the first number.
E.g. for a .2 dead zone turning left, change
left_key=(0.100000,-0.931517)WirelessController axis 5
to this
left_key=(-0.200000,-0.931517)WirelessController axis 5
Actually, looks like you had that set to pull left since the first number should have been negative due to being bound to the negative side of axis 5.
E.g. for a .2 dead zone turning left, change
left_key=(0.100000,-0.931517)WirelessController axis 5
to this
left_key=(-0.200000,-0.931517)WirelessController axis 5
Actually, looks like you had that set to pull left since the first number should have been negative due to being bound to the negative side of axis 5.
Josh Vanderhoof
Sole Proprietor
jlv@mxsimulator.com
If you email, put "MX Simulator" in the subject to make sure it gets through my spam filter.
Sole Proprietor
jlv@mxsimulator.com
If you email, put "MX Simulator" in the subject to make sure it gets through my spam filter.
Re: Can't figure out how to change my deadzone. Stick drift
That worked thanks jlvjlv wrote: ↑Sun Aug 13, 2023 1:01 am Increase the magnitude of the first number.
E.g. for a .2 dead zone turning left, change
left_key=(0.100000,-0.931517)WirelessController axis 5
to this
left_key=(-0.200000,-0.931517)WirelessController axis 5
Actually, looks like you had that set to pull left since the first number should have been negative due to being bound to the negative side of axis 5.